Home | The new issue | Inside Magazine

  N 1 (58) 2009

A. Zarjankin, V. Chernoshtan, V.Noskov, A. Rogalev.
How to increase the hydrodynamic load on clack valve plate's surface

The hydrodynamic load on check valve plate's surface has to be increased for holding the plate open and damping the pressure pulsation on the surface. This problem can be solved by changing plate's form. The new form of valve plates is suggested in the article. Standard 400 mm check valve was improved and tested.


 
 
 
 
  Information is available only in Russian
 
 
 
  Information is available only in Russian
 
 
  Information is available only in Russian
 
 
  Information is available only in Russian
 
 
  Information is available only in Russian
 
 
About Valve Industry magazine | Contacts| For authors| For advertisers| Subscription page | Exhibitions | Archives

Valve Industry magazine is registered by Ministry of Publishing, Tele- and Broadcasting and Mass Media of Russian Federation.
Certificate, dated May, 20, 2003
Advertiser is responsible for the validity (authenticity) of published advertising materials.
Publisher's opinion may disagree with authors' opinion.
© 2006-2010. All rights are reserved. The reprint of publications can be made only with the publisher’s permission.
While using publications references to Valve Industry magazine are required.